New NRA Steel Falling Plate 8″ Round Six Action Pistol Targets
Set of six 8″ round targets on 2″ x 4″ pads.
Targets round face is cut with a flat spot where it contacts the base so you get a much longer stronger weld.
Notice much longer weld.
Targets are manufactured per NRA specifications.
Plates are constructed of new 3/8 in. thick A36 steel
Shipped Via USPS Priority Mail – We normally ship same day as order is placed.
STEEL TARGETS: SAFETY AND USE From the FBI Training Bulletin There are many steel targets on the market allowing for a wide range of firearms training techniques. However, many of these targets do not provide adequate protection from bullet splatter so accidents can occur. It is important that the user know what factors make training on steel targets as safe and effective as possible. When shooting steel targets, a “splatter zone” appears. This zone is the area in which the great majority of bullet fragments eventually wind up. The total amount of splatter in this zone is primarily dependent on the following four key issues: 1) Angle of deflection, 2) Bullet design and 3) Target placement.
Please Be Sure To Check Out Our Other Auctions!
Please note: This target silhouettes are not for use with center fire rifles or shotgun slugs. Do not shoot steel targets from closer than 15 yards. Shooter and all spectators must wear safety glasses in case of flying spatter. It is required that shooters wear appropriate hearing protection. Discontinue use if target becomes damaged.
Disclaimer: Buyer assumes all responsibility for the use and misuse of the targets purchased.
8″ Round Falling Plate
Set of six 8″ round targets
2″ x 4″ pads
For lead target rounds, no hot factory or mag loads. Not for .223 rifle etc. We can make these out of AR500 (Very Hard Steel) but they will cost more.
A36 steel (Mild Steel) 3/8 in. thick